EMC Celerra Command Reference Manual page 338

The server Commands
Value
hits
misses
first poll hit
miss
Last offset
Current State
Time sync hosts IP address of the time server.
EXAMPLE #6
EXAMPLE #7
EXAMPLE #8
EXAMPLE #9
EXAMPLE #10
338
Celerra Network Server Command Reference Manual
Current State: Running, connected, interval=360
Time sync hosts:
0 1 172.24.102.20
Where:
Definition
when a client sends a request to the server requesting the current time, if there is a reply, that is a hit.
no reply from any of the time servers.
first poll hit which sets the first official time for the Data Mover.
first poll miss.
time difference between the time server and the Data Mover.
state of the time server.
To update time synchronization between a Data Mover and an
external source, type:
$ server_date server_2 timesvc update ntp
server_2 : done
To get the time zone on the specified Data Mover, type:
$ server_date server_2 timezone
server_2 : Local timezone:
To set the time zone to Central Time for a Data Mover when you do
not have to adjust for daylight savings time, type:
$ server_date server_2 timezone CST6
server_2 : done
To set the time zone to Central Time and adjust for daylight savings
time for a Data Mover, type:
$ server_date server_2 timezone CST6CDT5,M4.1.0,M10.5.0
server_2 : done
To display the time service configuration for a Data Mover, type:
$ server_date server_2 timesvc
server_2 :
Timeservice State
time:
type:
sync delay:
interval:
hosts:
GMT
Thu Jan 6 17:04:28 EST 2005
ntp
off
360
172.24.102.20,