EMC Celerra Command Reference Manual page 452

The server Commands
SEE ALSO
EXAMPLE #1
EXAMPLE #2
EXAMPLE #3
EXAMPLE #4
$ server_setup server_2 -Protocol cifs -option stop,comment="CIFS is going down"
server_2 : done
452
Celerra Network Server Command Reference Manual
[=<n>]
Indicates the number of threads for users of CIFS, virus
checker, and CDMS. The recommended number of CIFS
threads per user is based on the amount of memory on the
DM. If there is less than 1 GB memory, the default thread
number is 96, but if the memory is greater than 1 GB, the
default thread number is 256.
Note: The [=<n>] option is not available for RIP protocol
configurations.
stop
Stops the protocol configuration.
[,comment=<message>]
Allows a message enclosed with quotes to be entered. The
message is delivered directly to CIFS clients.
[,comment=
Note: The
or virus checker protocol configurations.
delete
Deletes the protocol configuration.
Configuring Standbys on Celerra, server_cdms, server_checkup,
server_mpfs, server_rip, server_standby, server_viruschk.
To set up a Data Mover as a standby, type:
$ server_setup server_2 -type standby
server_2 is rebooting as type standby
To start the CIFS protocol for a Data Mover, type:
$ server_setup server_2 -Protocol cifs -option start
server_2 : done
To start the virus checker protocol for a Data Mover, type:
$ server_setup server_2 -Protocol viruschk -option start
server_2 : done
To stop the CIFS protocol for a Data Mover, type:
option
<message>] is not available for RIP