EMC Celerra Command Reference Manual page 203

id = 2
name = server_3
acl = 1000, owner=nasadmin, ID=201
type = standby
slot = 3
member_of =
standbyfor= server_2
RDFstandby= slot=3
status :
defined = enabled
actual = online, ready
***** Servers configured as standby *****
No servers configured as standby
Where:
Value
Device Group
:
Configuration
name
description
uid
state
role
condition
recovery policy
number of mirrors
mode
owner
mirrored disks
local clarid
remote clarid
mirror direction
Value
Servers configured
with RDFstandby/
Servers configured
as standby
id
name
acl
type
slot
member_of
standby
Definition
name of the consistency (device) group
brief description of device group
UID assigned, based on the system
state of the device group (for example, Consistent, Synchronized, Out-of-Sync, Synchronizing,
Scrambled, Empty, Incomplete, or Local Only)
whether the current system is the Primary (source) or Secondary (destination) for this group
whether the group is functioning (Active), Inactive, Admin Fractured (suspended), Waiting on Sync,
System Fractured (which indicates link down), or Unknown
type of recovery policy (Automatic is the default and recommended value for group during backend
configuration; if Manual is set, you must use -resume after a link down failure)
number of mirrors in group
MirrorView mode (always SYNC in this release)
ACL ID assigned (0 indicates no control). See nas_acl.
comma-separated list of disks that are mirrored
APM number of local CLARiiON storage array
APM number of remote CLARiiON storage array
on primary system, local to remote (on primary system); on destination system, local from remote
Definition
server ID
server name
ACL value and owner
server type (for example, nas or standby)
slot number for this Data Mover
If applicable, shows membership information
If this Data Mover is configured with local standbys, the server that is the local standby and any policy
information
The nas Commands
203
nas_mview