Checking The Room Installation - Tunstall FlamencoIP Technical Manual

10. Functional checks
10.1

Checking the room installation

10.1.1 Checking every room for faults
 ComTerminal Flamenco or RoomTerminal Flamenco: Perform the test RAN, as
prescribed in the product leaflet for the Terminal. The LEDs of all operational
room devices will flash. After that call for the state in the display. If "OK" is dis-
played, the number of operational room devices equals to the RAN number set
at the Terminal.
 ControlTerminal Flamenco, ControlTerminal with doorplate Flamenco: Perform
the test RAN, as prescribed in the product leaflet for the Terminal. The LEDs of
all operational room devices will flash. Check whether the number of connected
room devices equals to the number of RAN users set with the ControlTerminal
ConfigSet.
 No fault may be indicated for the room at any of the following devices:
ComStation
PC
tion
tem" (red LED "Fault"), IP-SystemManager with operating mode "System +
Local" (red LED "Fault"), IP-SystemManager with operating mode "Local" (red
LED "Fault").
 Use the patient handset or the pear push switch to check for correct light switch-
ing.
 Use the patient handset to check for correct blinds control (if installed).
 Use the patient handset to check for correct entertainment reception (if installed).
 Use the patient handset to check for correct TV control.
54
BUS-C
, ComStation
PC
, ManagementCenter
CT
Flamenco, ComStation
, IP-SystemManager with operating mode "Sys-
IP
Flamenco - Technical Manual - 00 8813 52, 03/18 (Rev. 1.0)
T
Flamenco, ComSta-