Tunstall FlamencoIP Technical Manual page 134

Pneumatic call switches, Order No. 77 0216 0x...*), Installation Instructions
...*) The letter at the end of the order number represents the frame of the switch:
A = Frame dimensions (HxW): 91 x 91 mm, F = Frame dimensions (HxW): 80 x 80 mm
C = Frame dimensions (HxW): 107 x 107 mm. Caution! The frame C is made from real glass!
Note! The complete installation of the system is described in the Technical Manual.
Red LED
Red LED
Air hose
Rubber bulb (red)
Connecting the connector
Connect a 3-pole connector (order no. 70 0807 00) to the room
bus RAN (without speech) according to Fig. A.
Mounting
Wall mounting on 1-gang back box (see Fig. B):
1. Screw the support ring 7 to the back box 8* with the back box
screws 5*. The openings 6 in the support ring 7 for the locking
hooks 2 of the switch module 1 must be located on the top
and on the bottom, see Fig. B.
2. Lead the connected connector 4* through the support ring 7
out of the back box 8*.
3. Place the switch module 1 in the frame 3. The LEDs of the
switch module 1 must be located on the left side, see Fig. B.
4. Plug the connected connector 4* to the socket on the rear
side of the switch module 1.
5. Press the switch module 1 together with the frame 3 onto the
support ring 7 until it engages.
Warning! Call activation might be prevented. Do not kink the air
hose.
Dismantling
1. Lever the switch module 1 together with the frame 3 off the
support ring 7.
2. Remove the connector 4* from the switch module 1.
3. Undo the screws 5* of the support ring 7.
4. Remove the support ring 7.
00 8801 48, 05/15 (Rev. 3.0)
Pneumatic call switch, order no. 77 0216 00...*)
2 m air hose and red rubber bulb for raising calls or WC calls by squeezing the bulb
(factory setting: Calls). The LEDs (red) are on with a weak light for finding the pneu‐
matic call switch in the dark (night location light). The LEDs are on with a bright
light, when a call was raised (reassurance light).
Pneumatic call switch/WC, order no. 77 0216 01...*)
same as order no. 77 0216 00..., but factory setting: WC call.
3
Product leaflets 03/2018, page 19
B(lack) = 0 V
Y(ellow) = RAN
From a RAN user
R(ed) = +24V-Si
5*
4*
2
6
3
1
1 Switch module
2 Locking hooks
3 Frame
4* Connector, 3-pole
(order no. 70 0807 00)
5* Back box screws
6 Openings for the locking
9
hooks
7 Support ring
8* Back box, 1-gang
(solid wall: 17 0100 00,
partition wall: 17 5100 00)
9 Air hose
10 Rubber bulb
10
* is not included with
product delivery.
English
B
Y
R
6
5*
8*
7