Advertisement
Quick Links
Tunstall Canada Inc, 111 Zenway Blvd, Unit 6A Woodbridge, Ontario Canada L4H 3H9
Tel: 1-800-892-2205 Email: info.canada@tunstall.com
Tunstall Americas., 36-36 33rd St., Suite 103 Long Island City, NY 11106USA
Tel: 1-800-286-2622 Email: us.info@tunstall.com
Programming the Vi+ using a Series Telephone
Tunstall Vi+
Programming the Vi+ using
a SeriesTelephone
Advertisement
Related Manuals for Tunstall Vi+
Summary of Contents for Tunstall Vi+
- Page 1 Tunstall Vi+ Programming the Vi+ using a SeriesTelephone Tunstall Canada Inc, 111 Zenway Blvd, Unit 6A Woodbridge, Ontario Canada L4H 3H9 Tel: 1-800-892-2205 Email: info.canada@tunstall.com Tunstall Americas., 36-36 33rd St., Suite 103 Long Island City, NY 11106USA Tel: 1-800-286-2622 Email: us.info@tunstall.com...
- Page 2 Programming the Vi+ using a Series Telephone Your Vi+ Page 2 Ver 1 4/24/2015...
-
Page 3: Range Test
Programming the Vi+ using a Series Telephone Programming a telecare sensor to the Vi+ Telecare sensors with plug and play functionality can be programmed to the Vi+ using the following steps: Step 1 – Press and hold down the green cancel button until it bleeps (approx. - Page 4 Step 3 – Lift the handset of the telephone and enter the quick codes listed on the following pages. Manual entry of parameters can also be completed via this method; however this should only be used when advised by Tunstall. Frequently used series telephone codes...
-
Page 5: Telephone Numbers
3020. The unit will then announce the date and time. During the first 30 minutes of installation the Tunstall Vi+ will also announce the date and time when an incoming telephone call is received (requires CLI on the telephone line). To set the clock... - Page 6 Programming the Vi+ using a Series Telephone Changing telephone number destination to PR or POTS To program an existing telephone number to a PR or POTS destination, press: Where X represents the telephone number position (1-9 with 0 = 10) Where Y represents the destination type CC (0), PR (1) and POTS NOTE: It is important to set the correct destination type otherwise the recipient of the alarm call will not be able to deal with it correctly.
- Page 7 Programming the Vi+ using a Series Telephone Unit ID numbers The Vi+ sends a unit ID number to the monitoring center when an alarm is sent. The number identifies which Vi+ is sending the alarm. Unit ID number 1 must be programmed into the Vi+ (default 995) in order for an alarm to be sent.
- Page 8 Programming the Vi+ using a Series Telephone User Options Codes The following table provides a two digit code that enables you to set parameter 11 very simply. For example, to set a Vi+ to have; No inactivity monitoring, no line fail warnings (audio or visual) but with electrical power audio fail warning on, press;...
-
Page 9: Quick Codes
Programming the Vi+ using a Series Telephone Quick Codes The Tunstall Vi+ has a number of quick codes that can be entered into the series telephone when the Vi+ is in programming mode Quick Purpose Comments Code 2040 Reset to default but retain radio triggers...