Overview Of Error Blink Codes - WAGO I/O SYSTEM 750 750-671 Manual

3.3.1 Overview of Error Blink Codes

Error
No.
1111
1112
1113
1114
1115
1116
1117
1118
1121
1122
1123
1124
WAGO-I/O-SYSTEM 750
I/O Modules
Name
CI_UNKNOWN
COMMAND
CI_UNKNOWN
COMMAND2
CI_ERR1
CI_NOT
IMPLEMENTED
CI_COMMAND_
DENIED
CI_SPEED1
CI_SPEED2
CI_SPEED3
CI_ACC1
CI_ACC2
CI_
ROUNDARYSHAFT
_
SETPOINT
CI_POS_TABLE
Overview of Error Blink Codes
Description
INT
Unknown command
Unknown command,
like Error 1112
Command not
implemented
Could not execute
command
Configuration: Invalid
maximum frequency
Invalid frequency value
internal
Invalid acceleration
value
Invalid acceleration
value
Operation with rotary
shaft: absolute position
setpoint output of rotary
shaft range
Invalid table selected for
positioning to position
table
Auxiliary Commands
Possible cause/Remedy
A Drive command was
received with an unknown
command. Check command
(and possibly the move
program)
Same as for Error 1112
Command has been
prepared but has not (yet)
been implemented,
otherwise same as Error
1112
It was not possible to
execute a command, as the
marginal conditions do not
permit it. (incorrect mode,
incorrect parameter, .... for
this command)
Unacceptable value
specified for maximum
frequency
Unacceptable value
specified for set frequency
Check the specified
acceleration value
(configuration, Move
program, process data ....)
Same as for Error 1121
During operation with the
rotary shaft, the absolute
position must lie within the
range 0 ...
RotaryShaftRange. Check
the position data and
parameters for the rotary
shaft.
Check Parameter 2 for a
command "MOVE_L"
• 207