Table of Contents
Advertisement
11
Installation and Maintenance
Insert module
along the direction shown
by this arrow
332
Tighten Retaining Screws
Figure 208
1
Position the module at the rear of the instrument as shown in
208
2
Insert the module into the mainframe, using the handle, being careful
to keep the module completely flat. If the module does not slide freely,
check that you have correctly oriented it and that there is no
obstruction to its movement.
If you insert the module at an angle or vertically, you may damage the
CAUTION
instrument and the module. You should insert the module along the
direction shown by the arrow in
Fitting a Back-Loadable Module
on page -332.
Figure 208
on page -332.
8163A/B, 8164A/B, 8166A/B User's Guide
Figure
Hide quick links:
Advertisement
Table of Contents
