10
Applications
296
The application chooses the power level, [P], see step 15 for more
NOTE
information.
The application chooses the power level, [P], see
information.
25 There are two softkeys available from the PACT Measurement screen.
•
Press [Graph] to view a graph of the Measurement results as the
results are measured. Press [Close] to return to the PACT Reference
Measurement screen. See
page 249 for information on zooming in and out.
•
Press [Cancel] to return to the PACT Reference screen without
completing the stability application.
If you choose <High> or <Medium> as the [Dynamic] parameter and
NOTE
<Continuous> sweep mode, the graph will update at the end of each
sweep.
that is the result of a single sweep.
with high dynamic range that is the result of a three sweeps that were
combined using a "stitching" process.
on page -72 shows a graph with low dynamic range
Figure 34
step 14
Working with Application Graphs
on page -87 shows a graph
Figure 49
8163A/B, 8164A/B, 8166A/B User's Guide
for more
on