Table of Contents
Advertisement
5
Tunable Lasers
164
Figure 93
Input Trigger Mode
4
Move to one of the following, by using the cursor key:
•
<Ignore>, input triggers are ignored.
•
<Next Step>, an input trigger will cause the next step of a stepped
sweep to be performed.
•
<Run Sweep>, an input trigger will start a single sweep cycle.
5
Press Enter.
You can generate input triggers in any of the following ways:
•
applying a trigger to the Input Trigger Connector on the rear panel
of your instrument,
•
setting <Trigger Configuration> to <Loopback> so that an output
trigger automatically generates an input trigger, or
•
using the :TRIGger GPIB command, see your mainframe's
Programming Guide.
8163A/B, 8164A/B, 8166A/B User's Guide
Hide quick links:
Advertisement
Table of Contents
