Keysight Technologies 8163A User Manual page 151

5 Tunable Lasers
150
14 Move to [Dwell] and press Enter.
15 Enter 0.5000 and press Enter.
16 Press the [Active] hardkey on the front panel of your Tunable Laser
module to enable the optical output.
17 Press [Run Swp] to start the sweep. The screen in
page -150 appears.
18 The wavelength is swept automatically but you can:
a press [Stop] to end the sweep, or
b press [Pause] to pause the sweep. The screen in
page -151 appears. You can:
• Press [Continue] to continue sweeping automatically.
• Press [Prev] or [Next] to sweep manually.
• Press [Stop] to end the sweep.
Figure 86 Executing a Stepped Sweep
Figure 86
Figure 87
8163A/B, 8164A/B, 8166A/B User's Guide
on
on