8163A/B, 8164A/B, 8166A/B User's Guide
Selecting/Deselecting Power Meters
8
Move to the Module Selection box. As a default, all Power Meters are
selected, this means that all Power Meters will log power
measurements. Press [Edit].
9
To deselect a Power Meter channel, move to the Power Meter as
denoted by slot and channel numbers, see
on page 39, press [Unset].
To select a Power Meter channel, press [Edit], move to the Power Meter as
denoted by slot and channel numbers, see
page 39, press [Set].
10 Perform steps until you have selected the required Power Meters for
your application and press Enter.
If no Power Meter channel is selected, you cannot exit by pressing Enter.
NOTE
Setting Sweep Parameters
11 Move to [
and press Enter.
12 Move to [
and press Enter.
13 Move to [Step], press Enter, enter the step size for the sweep, and
press Enter.
The step size defines:
NOTE
the size of the change in the wavelength for each step of a stepped
sweep and
the wavelength interval between power measurements, the first power
measurement is taken at [
14 Move to [P max], press Enter, enter the maximum power in dBm for the
sweep, and press Enter. The instrument chooses a constant power
level for the measurement using the following constraints:
•
the power will be less than or equal to the [P max] value you set and
λ
Start], press Enter, enter the start wavelength of the sweep,
λ
Stop], press Enter, enter the stop wavelength of the sweep,
Start] and the last must be taken at [
λ
Applications
Slot and Channel Numbers
Slot and Channel Numbers
10
on
Stop].
λ
289