Bypass Advanced Settings; Step By Step Example - Pitney Bowes F65A Operator's Manual

Bypass advanced settings

The system asks if Advanced Settings should be bypassed. Pressing RED will display the
advanced settings. Proceed through the following four parameters by pressing GREEN to
continue and the Arrow Buttons to edit the selection.
Set Integrity/WAS/SSQ:
-LSB (least significant bit)
-MSB (most significant bit)
Set Integrity random:
-NO
-YES
OMR scanning:
-NORMAL
-REVERSE
Dist. Lead.edge to benchmark: XXXmm

Step by step example

In this following example an OMR code will be programmed in full. The code below will be
used as a template.
In this example there are nine scan line positions defined while the last four remain unas-
signed. The bench mark control (BM) is set permanently to scan line position 1. Press
GREEN to confirm.
DVF
<-->=SELECT Green=CONF. Blue=END Red=IGNORE
The display shows the above. Scroll through the scan functions and select EOC
EOC
<-->=SELECT Green=CONF. Blue=END Red=IGNORE
In the above OMR code there are three wrap around sequences (WAS). This means that
WAS3 must be selected. If you choose excluding 0, the system counts to 6, else it counts
to 7. This results out of the system's binary counting method. Confirm by pressing GREEN.
WAS3
<-->=SELECT Green=CONF. Blue=END Red=IGNORE
: [ 2]
: [ 2]
: [ 3]
27