Table of Contents
Advertisement
Replacing a hard drive
Two hot-swappable SCSI drives are installed in your chassis. You do not need to remove the
chassis cover to add or replace a hot-swap hard drive, but you must remove the front bezel to
access the hard drives.
Important:
The replacement hard drive must be the same size or larger than the drive being replaced.
To replace a SCSI hard drive
1. Remove the front bezel. Refer to
2. Attach the ESD strap to your wrist and attach the other end to a known grounded
3. Locate the faulty hard drive. Refer to the following diagram of the front panel.
Figure 15: Front panel
4. Press the green latch (A) on the front of the hard drive carrier as shown in the
Avaya CallPilot® 1005r Server Maintenance and Diagnostics
for instructions.
connection.
• Hard drive 0 is on the right (T). The status LED of hard drive 0 is marked with the
hard drive symbol and the number 0 (M).
• Hard drive 1 is on the left (R). The status LED of hard drive 1 is marked with
the hard drive symbol and the number 1 (L).
following diagram.
Removing and replacing the front bezel
Replacing a hard drive
on page 69
December 2010
75
Advertisement
Table of Contents
