Alert Icons - Avaya CallPilot 1005r Maintenance And Diagnostics

Monitoring multimedia hardware
State
Idle
InTest
Loading
Local (Red) Alarm
No resources
Not Configured
Off Duty
Remote Off Duty
Remote (Yellow)
Alarm
Shutting Down
Uninitiated

Alert icons

If one of the following icons appears next to a component in the tree, then the component or
one of its subcomponents is experiencing a problem:
Icon
A problem exists with a subcomponent of the selected component. Expand the
tree to locate the subcomponent with the problem.
A problem exists with the selected component.
To view the state of a hardware component
1. Run CallPilot Manager and log on.
2. In CallPilot Manager, click Maintenance > Maintenance Admin.
50 Avaya CallPilot® 1005r Server Maintenance and Diagnostics
The component is working but not currently involved in processing
a call.
A diagnostic is running on the resource or device.
The component has started and takes it out of the Off Duty state.
This state occurs quickly and is immediately followed by Idle.
A Receive Loss of Synchronization error occurred on incoming data
over a T1 link and lasted more than 2.5 seconds. This condition
exists until synchronization is recovered and remains recovered for
12 seconds.
The hardware required for the component to operate is not installed
or is not operating properly.
The device is not configured in CallPilot.
For example, a DSP is not being used because it was not allocated in
the Configuration Wizard.
The component has been stopped.
The component has been taken out of service at the switch.
A red alarm exists at the receiving device. This alarm is sent by the
receiving T1 device to CallPilot, and it remains in effect until the red
alarm is cleared at the receiving device.
The component is in the process of stopping.
This state occurs quickly and is immediately followed by Off Duty.
The call processing component has not initialized the resource.
Description
Description
December 2010