Requirements - Avaya CallPilot 1005r Maintenance And Diagnostics

Replacing basic chassis components

Requirements

You need a Phillips (cross head) screwdriver, #1 and #2 bit.
To replace the DVD combo drive
1. Power down the server, unplug all peripheral devices and Ethernet cables, and
2. Remove the front bezel. Refer to
3. Attach the ESD strap to your wrist and attach the other end to a known grounded
4. Remove the chassis cover. Refer to
5. Pull out on the drive carrier handle (A) as shown in the following diagram.
Figure 25: DVD combo drive assembly
6. Slide the DVD combo drive assembly from the chassis.
7. Remove the screw on the left side of the drive assembly and save it for installing
8. Remove the DVD combo drive from the carrier.
84 Avaya CallPilot® 1005r Server Maintenance and Diagnostics
disconnect the AC power.
page 69.
connection.
page 70 for instructions.
Note:
There are no cables to disconnect.
the new DVD combo.
a. Open the two latches holding the DVD combo drive in the carrier.
b. Disconnect the ribbon cable.
c. Disconnect the power cable from the DVD combo drive.
Removing and replacing the front bezel
Removing and replacing the server cover
on
on
December 2010