Table of Contents
Advertisement
Replacing basic chassis components
To replace the server cover
1. Place the cover over the chassis so that the side edges of the cover sit just inside
2. Press down slightly on the chassis cover behind the DVD combo drive area and
Removing and replacing the processor air duct
You must remove the air duct to access the processor assembly, four-fan assembly, and the
memory modules. Because the processor air duct channels the airflow within the chassis, be
sure to reinstall the air duct before installing the chassis cover.
Requirements
You need a Phillips (cross head) screwdriver, #1 and #2 bit.
To remove the processor air duct
1. Power down the server, unplug all peripheral devices and Ethernet cables, and
2. Attach the ESD strap to your wrist and attach the other end to a known grounded
3. Remove the chassis cover. Refer to
4. Remove the screws at the top of the air duct.
72
Avaya CallPilot® 1005r Server Maintenance and Diagnostics
the chassis sidewalls. The front of the cover is about an eighth of an inch from the
sheet metal at the front of the chassis. Refer to
71.
slide the cover forward until it clicks into place.
disconnect the AC power.
connection.
page 70.
Figure 12: Server cover
Removing and replacing the server cover
on page
on
December 2010
Advertisement
Table of Contents
