Requirements - Avaya CallPilot 1005r Maintenance And Diagnostics

RAID operations
Caution:
Risk of electrical damage
• Wear an antistatic ESD wrist strap when handling cards or boards, or when working
inside the server.
• Do not touch the components or gold-edge connectors of cards or boards.
• Place the card on an antistatic surface until you are ready to install it.
PCI add-in cards are not hot-swappable. You must power down the system and remove the
power cords before replacing the card.
Caution:
Risk of physical equipment damage
Remove the 1005r from the rack, and place it on a solid surface when replacing or adding
cards. The PCI riser assembly requires considerable force when inserting it into the
connector, and physical damage can result if the assembly is not properly aligned.
Placing the server on a solid surface such as a workbench gives you a better view of the
card alignment and lets you exert the necessary force when inserting the assembly into the
connector.

Requirements

• Phillips (cross head) screwdriver, #1 and #2 bit
• RAID card replacement kit
• electrostatic discharge (ESD) grounding strap
To replace the RAID card
1. Power down the server, unplug all peripheral devices and ethernet cables, and
2. Attach the ESD strap to your wrist and attach the other end to a grounded
3. Remove the chassis cover. Refer to
4. Disconnect the red power cable from the PCI riser assembly.
5. Disconnect the DS30X cable from the MPB96 board in the full-size side of the PCI
98 Avaya CallPilot® 1005r Server Maintenance and Diagnostics
disconnect the AC power.
connection away from the server.
page 70 for instructions.
riser. If you have an NTRH40CA MPB96 board or boards, disconnect the DS30
cables from the RJ-45 connectors.
Removing and replacing the server cover on
December 2010