Table of Contents
Advertisement
Maintaining the BIOS and system board firmware
10. Enter Y to confirm.
11. Remove the Image DVD from the DVD combo drive and enter any key.
12. The BIOS upgrade is complete.
BIOS settings
Table 17: BIOS settings
boots, press F2 to enter the 1005r BIOS. BIOS Settings that are in bold text are settings that
are modified by Avaya.
Table 17: BIOS settings
Main
Advanced
124
Avaya CallPilot® 1005r Server Maintenance and Diagnostics
Result: The BMC update progress dialog box appears with the following message:
System will now reboot.
Press any key to continue...
Result: The system reboots.
on page 124 displays the 1005r server BIOS settings. As the system
Set the Date and the language to English
Processor Configuration
IDE Configuration
Floppy Configuration
Super I/O Configuration
Processor Re-test: Disabled Max
CPU ID Value Limit: Disabled
Hyper treading Technology:
Enabled HT Technology in MPS:
ENABLED Execute Disable Bit:
Enabled Hardware Prefetcher:
Disabled Adjacent Cache Line
Prefetch: Disabled
Onboard P-ATA Channels:
PRIMARY Onboard S-ATA
Channels: DISABLED Primary IDE
master: ATAPI CDROM Primary
IDE slave: Not Detected Secondary
IDE Slave: Not Detected Third IDE
Master: Not Detected Fourth IDE
master: Not Detected Hard Disk
write protection: Disabled IDE
Detect Time Out: 35 sec ATA(PI) 80
pin Cable Detection: Host&Device
Onboard FDD Disabled
Serial Port Trimode:Mode1 BMC
Snoop SIM Tri state: Disabled
Serial Port A Address: 3F8/IRQ4
Serial Port B Address: 2F8/IRQ3
December 2010
Advertisement
Table of Contents
