Replacing A Hard Drive - Avaya CallPilot 600r Maintenance And Diagnostics

Replacing basic chassis components
Figure 17: Removing the power supply
6. Lift the power supply from the chassis.
7. Insert the replacement power supply. Ensure that you insert the terminal block
8. Plug the new power supply into the AC mains.
9. Lower the power supply into place. Ensure that the cables are not pinched under
10. Push firmly at the rear of the power supply to push the connector at the front of the
11. Install the PCI riser assembly. For instructions, see
12. Replace the connector cover over the completed connections.
13. Install the server cover. For instructions, see

Replacing a hard drive

The 600r server has one SCSI drive. You do not need to remove the server cover to add or
replace a hard drive, but you must remove the front bezel.
Important:
You must replace the hard drive with an identical unit or other Avaya-approved hard drive.
78 Avaya CallPilot® 600r Server Maintenance and Diagnostics
through the hole in the rear of the chassis. Move any cables away from where the
power supply is inserted so that the cables are not pinched or damaged.
the power supply. For more details, see
page 78.
power supply into the power board.
page 82.
cover on page 74.
Figure 17: Removing the power supply
Replacing the MPB96 card
Removing and replacing the server
on
on
December 2010