Source Subsystem (Phase) Commands; Subsystem Syntax; Phase - Keysight Technologies 6811C Programming Manual

Source Subsystem (Phase) Commands

This subsystem programs the output phases. When phase commands are used to
program single-phase units, the only discernible effect in using the phase
commands is to cause an instantaneous shift in the output waveform phase.

Subsystem syntax

[SOURce:]

PHASe

This command sets the phase of the output voltage waveform relative to an
internal reference. The phase angle is programmed in degrees. Positive phase
angles are used to program the leading phase, and negative phase angles are
used to program the lagging phase.
Returned parameters <NR3>
Keysight Models 6811C, 6812C, and 6813C Programming Guide
PHASe
[:ADJust|:IMMediate] <n>
:AUXiliary
[:ADJust|:IMMediate] <n> Sets the output phase
:MODE <mode>
:TRIGgered <n>
Command syntax [SOURce:]PHASe[:ADJust|:IMMediate] <NRf+>
Parameters –360 through +360 (degrees) | MAXimum | MINimum
*RST value 0
Examples
PHAS 90
Query syntax [SOURce:]PHASe[:ADJust|:IMMediate]?
Related commands PHAS:MODE
Sets the output phase
Sets the phase mode (FIX | STEP | PULS | LIST)
Sets the triggered phase (step or pulse mode only)
PHAS MAX
PHAS:TRIG
Language Dictionary 3
147