Status:preset; Status:operation - Keysight Technologies 6811C Programming Manual

STATus:PRESet

This command sets the Enable, PTR, and NTR registers of the status groups to
their power-on values. These values are as follows:
– Enable Registers: All bits set to 0 (OFF)
– PTR Registers: All defined bits set to 1 (ON)
– NTR Registers: All bits set to 0 (OFF)
Bit configuration of Operation Status registers
Bit position
Bit name
Bit weight
n.u. = Not used
CAL = Interface is computing new calibration constants.
WTG = Interface is waiting for a trigger.
CV = Output voltage is regulated.

STATus:OPERation?

This query returns the value of the Operation Event register. The Event register is a
read-only register which holds (latches) all events that are passed by the
Operation NTR and/or PTR filter. Reading the Operation Event register clears it.
Returned parameters <NR1> (register value)
Keysight Models 6811C, 6812C, and 6813C Programming Guide
Command syntax STATus:PRESet
Parameters None
Examples
STAT:PRES
15 – 9
n.u.
Query syntax STATus:OPERation[:EVENt]?
Parameters None
Examples
STAT:OPER:EVEN?
Related commands *CLS
8 7 – 6
CV n.u.
256
STAT:OPER:NTR STAT:OPER:PTR
Language Dictionary
5 4 – 1
WTG n.u.
32
3
0
CAL
1
169