Keysight Technologies 6811C Programming Manual page 260

5 Programming Examples
Register
Event
Enable
The outputs of the Operation Status register group are logically-ORed into the
OPER(ation) summary bit (7) of the Status Byte register.
Table 5-1
Bit
0
5
8
0
1
2
3
4
9
10
11
12
14
260
Command
STAT:OPER:EVEN?
STAT:OPER:ENAB? <n>
Bit configuration of status registers
Signal Meaning
Operation status group
CAL Interface is computing new cal constants
WTG Interface is waiting for a trigger
CV The output voltage is regulated
Questionable and questionable instrument isummary status groups
OV The overvoltage protection circuit has tripped
OCP The overcurrent protection circuit has tripped
SOA The safe operating area protection has tripped
UNR The output is unregulated
OT An overtemperature condition has occurred
RI The remote inhibit state is active
CLpeak The peak current limit circuit is active
Rail The rail protection circuit has tripped
CLrms The rms current limit circuit is active
MeasOvld Current measurement exceeded capability of low range
Keysight Models 6811C, 6812C, and 6813C Programming Guide
Description
A register that latches any condition that is passed through
the PTR or NTR filters. It is a read-only register that is
cleared when read.
A register that functions as a mask for enabling specific bits
from the Event register. It is a read/write register.