List:voltage:offset:slew; List:voltage:offset:slew:points - Keysight Technologies 6811C Programming Manual

3 Language Dictionary

LIST:VOLTage:OFFSet:SLEW

This command specifies the DC offset slew list points. The slew points are given in
the command parameters, which are separated by commas. The order in which
the points are entered determines the sequence in which they are output when a
list is triggered. Changing list data while a subsystem is in list mode generates an
implied ABORt.
Returned parameters <NR3>{, <NR3>}

LIST:VOLTage:OFFSet:SLEW:POINts?

This query returns the number of points specified in LIST:VOLTage:OFFSet:SLEW.
Note that it returns only the total number of points, not the point values.
Returned parameters <NR1>
146
Command syntax [SOURce:]LIST:VOLTage:OFFSet:SLEW <NRf+> | INF {, <NRf+> | INF}
Parameters 0 to 9.9E37 | MAXimum | MINimum | INFinity
Unit V (volts per second)
Examples
LIST:VOLT:OFFS:SLEW 10, 20, 1E2
Query syntax [SOURce:]LIST:VOLTage:OFFSet:SLEW?
Related commands LIST:VOLT:SLEW:POIN?
Query syntax [SOURce:]LIST:VOLTage:OFFSet:SLEW:POINts?
Examples
LIST:VOLT:OFFS:SLEW:POIN?
Related commands LIST:VOLT:OFFS:SLEW
Keysight Models 6811C, 6812C, and 6813C Programming Guide
LIST:COUN LIST:DWEL LIST:STEP