List:phase; List:phase:points - Keysight Technologies 6811C Programming Manual

3 Language Dictionary

LIST:PHASe

This command sets the sequence of phase list points. The phase points are given
in the command parameters, which are separated by commas. The order in which
the points are entered determines the sequence in which they are output when a
list is triggered. Changing list data while a subsystem is in list mode generates an
implied ABORt.
Returned parameters <NR3>{, <NR3>}

LIST:PHASe:POINts?

This query returns the number of points specified in LIST:PHASe. Note that it
returns only the total number of points, not the point values.
Returned parameters <NR1>
140
Command syntax [SOURce:]LIST:PHASe <NRf+>{, <NRf+>}
Parameters –360 through +360 (degrees) | MAXimum | MINimum
Examples
LIST:PHAS 90, 120, 150
Query syntax [SOURce:]LIST:PHASe?
Related commands LIST:FREQ:POIN?
Query syntax [SOURce:]LIST:PHASe:POINts?
Examples
LIST:PHAS:POIN?
Related commands LIST:PHAS
Keysight Models 6811C, 6812C, and 6813C Programming Guide
LIST:COUN LIST:DWEL LIST:STEP