Fip-Ac Power - Fuji Xerox DocuPrint CM305 df Service Manual

FIP-AC Power

Step
Possible causative parts:
SWITCH ASSY INLET MG AIO (PL8.3.7)
PWBA LVPS (PL8.2.12)
Checking the printer.
1 Does the motor noise arise when turning on the power?
During this test, close the COVER ASSY FRONT MG.
Checking the power supply on wall outlet.
2 Connect the power cord with other wall outlet.
Does the printer operate normally?
Checking the power code for connection.
3 Reconnect the power cord.
Does the printer operate normally?
Checking the connector of SWITCH ASSY INLET MG AIO
for connection.
Disconnect the power cord and wait for one minute.
4
Reconnect the connector of SWITCH ASSY INLET MG
AIO.
Does the printer operate normally?
Checking the connector of PWBA LVPS for connection.
Disconnect the power cord and wait for one minute.
5
Reconnect the all connectors of PWBA LVPS.
Does the printer operate normally?
Check
2 - 179
Chapter 2 Troubleshooting
Remedy
Yes
Go to FIP-DC. Go to step 2.
End of work. Go to step 3.
End of work. Go to step 4.
Replace the
SWITCH ASSY
End of work.
INLET MG AIO,
then go to step 5.
Replace the
End of work. PWBA LVPS
(Refer to REP8.9.)
No