Fip-1.P11 Fog - Fuji Xerox DocuPrint CM305 df Service Manual

FIP-1.P11 Fog

Mnt01115KA
Before commencing troubleshooting, check the paper transfer path. Make sure there is no foreign
materials on the transfer path, such as staples, paper clips, scraps of paper and so on.
Step
Checking the error mode.
1
Does the error occur only during copying?
Checking the original.
2
Is the original color clean?
Checking the Default setting.
3 Is the [Lighter/Darker] of the [Copy Default] in the [Copy] of
the [Default Settings] the [Darker 2 or 3]?
Checking the printing.
4 Checked by [Test Print] - [Gradation] in diagnosis.
Is the image printed correctly?
Changing the printer driver setting.
Reset Image Settings (Brightness/Contrast) to defaults.
5 - Click [Restore Defaults] in [Image Settings] on the
[Graphics] tab.
Is the image printed correctly?
Checking the paper.
6 Is the installed paper with a new and dry one? or does the
paper satisfy the specification?
Checking after "Drum Refresh Mode".
Execute the "Drum Refresh Mode".
7 - To execute the "Drum Refresh Mode", click [Drum Refresh
Mode] in [Refresh Mode] on the diagnosis tab of Tool Box.
Is the image printed correctly?
Check
3 - 28
Chapter 3 Image Quality Troubleshooting
ESS and possible causative parts
- PWBA HVPS (PL4.1.19)
- PHD ASSY (PL4.1.21)
Yes
Go to step 2.
Go to step 3.
Set the [Normal]
or [Lighter 1 to 3].
Printing data is
incorrect,then
check the printing
data which the
problem
generated.
End of work.
Go to step 7.
End of work.
Remedy
No
Go to step 4.
END, change the
original.
Go to step 5.
Go to step 5.
Go to step 6.
Replace the paper
with a new and dry
one. or Change
the paper to the
one that satisfies
the specification.
Go to step 8.