- Checking Motor, Clutch and Solenoid
NOTE
Before executing the Motor Test, close all covers and doors.
Motor/Clutch/Solenoid Name
(Diag. Code)
Main Motor (FULL2/FULL1/HALF)
NOTE: This procedure is for the technical staff.
When performing operation for five minutes or longer with the front cover
open, remove the PHD ASSY, and cover the drum to avoid exposure to light.
1)
Power on the printer, and enter the Diag Mode.
2)
Open the Front Cover
3)
Cheat the Safety Interlock System.
4)
Execute the Main Motor (FULL2,FULL1 or HALF).
5)
Check that the Drum rotates.
Drum
Belt
6)
Press the "STOP" key to stop the test.
7)
Remove the cheater.
8)
Close the Front Cover.
6 – 103
Check procedure
Chapter 6 General
MiA02015GA