Fuji Xerox DocuPrint CM305 df Service Manual page 756

Motor/Clutch/Solenoid Name
(Diag. Code)
Tray2 Turn Roll
NOTE: This procedure is for the technical staff.
Combination test is as follows:
Tray 2 turn roll rotates when the the Tray2 Feeder Motor and the the Tray2 Turn
Roll are executed.
1) Remove the COVER CHUTE.
2) Power on the printer, and enter the Diag Mode.
3) Remove the Tray 1 and Tray 2.
4) Execute the Tray2 Feeder Motor or the Tray2 Turn Roll.
5) Check that the Turn Roll rotates.
Tray 2 Turn Roll
6) Press the "STOP" key to stop the clutch.
7) Press the "" key to display the Tray2 Feeder Motor.
8) Press the "STOP" key to stop the motor.
9) Replace the COVER CHUTE, Tray 1 and Tray 2.
6 – 110
Check procedure
Chapter 6 General
MiA02027GA