Fuji Xerox DocuPrint CM305 df Service Manual page 356

[Replacement]
1) Close the COVER ASSY FRONT.
2) Fit the ROLL ASSY FEED to the
SHAFT ASSY FEED with the
groove of the ROLL ASSY FEED
facing upward, rotate the ROLL
ASSY FEED 180 degrees so that the
pin on the SHAFT ASSY FEED is
aligned with the groove on the
ROLL ASSY FEED.
3) Open the COVER ASSY FRONT.
4) Move the ROLL ASSY FEED to the
right side, put the groove of the
ROLL ASSY FEED on the pin of the
SHAFT ASSY FEED.
Chapter 4 Disassembly / Assembly and Adjustments
4 - 80