Fuji Xerox DocuPrint CM305 df Service Manual page 235

FIP-1.P3 Part or the entire output is black.
Before commencing troubleshooting, check the paper transfer path. Make sure there is no foreign
materials on the transfer path, such as staples, paper clips, scraps of paper and so on.
Step
Checking the error mode.
1
Does the error occur only during copying?
Checking the original.
2
Is the original placed correctly?
Checking the solid black.
3 Checked by [Test Print] - [Test Pattern 600] in diagnostic.
Is the image printed correctly?
Checking the printer driver setting.
4 Is the [Output Color] option under the [Graphics] tab set to
"Color (Auto)"?
Checking the Toner Type
5
Is the XEROX Toner seated?
Checking after resetting the PHD ASSY.
6 Reseat the PHD ASSY.
Is the image printed correctly?
Checking after resetting the PWBA HVPS.
7 Reseat the PWBA HVPS.
Is the image printed correctly?
Checking after replacing the PHD ASSY.
8 Replace the PHD ASSY. (Refer to REP4.6.)
Is the image printed correctly?
Check
3 - 13
Chapter 3 Image Quality Troubleshooting
ESS and possible causative parts
- PWBA HVPS (PL4.1.19)
- PHD ASSY (PL4.1.21)
Yes
Go to step 2.
Go to step 4.
Printing data is
incorrect, then
check the printing
data which the
problem
generated.
Go to step 5.
Go to step 6.
End of work.
End of work.
End of work.
Remedy
No
Go to step 3.
Set the original
correctly.
Go to step 4.
Set the option to
"Color (Auto)".
Replace the toner
with the XEROX
toner.
Go to step 7.
Go to step 8.
Replace the
PWBA HVPS.
(Refer to REP4.5.)