Motor/Clutch/Solenoid Name
(Diag. Code)
Tray1 Feed SOLENOID (Half/Initial
Position Rotation)
Exit Motor (FULL1/ FULL2/ FULL3
/HALF)
1)
Power on the printer, and enter the Diag Mode.
2)
Open the Tray 1.
3)
Execute the Tray1 Feed SOLENOID (Half or Init).
4)
Check that the Feed Roll rotates.
5)
Press the "STOP" key to stop the test.
6)
Replace the Tray 1.
1)
Power on the printer, and enter the Diag Mode.
2)
Execute the Exit Motor (FULL1,FULL2,FULL3 or HALF).
3)
Check that the Exit Roll rotates.
Exit Roll
4)
Press the "STOP" key to stop the test.
6 – 105
Check procedure
Feed Roll
Chapter 6 General
MiA02018GA
MiA02019GA