Fuji Xerox DocuPrint CM305 df Service Manual page 162

Step
Checking the HOLDER ASSY SEPARATOR on the Tray 1
for shape and rotation.
9 Pull the Tray 1 out from the printer.
Is the HOLDER ASSY SEPARATOR not contaminated and/
or damaged, and rotated smoothly?
Checking the ROLL ASSY FEED for shape and rotation.
Pull the Tray 1 out from the printer.
10
Is the ROLL ASSY FEED not contaminated and/or
damaged, and rotated smoothly?
Checking the Cassette Feed Solenoid (SOLENOID FEED)
for operation.
Does the Cassette Feed Solenoid (SOLENOID FEED)
operate properly?
11
Checked by [Digital Output] - [Tray1 Feed Solenoid] in [IOT
Diag] of diagnosis.
During this check, cheat the interlock switch (HARN ASSY
INTERLOCK AIO).
Checking the paper lead edge staying position.
12 Does the paper lead edge stay before the ROLL ASSY
REGI and ROLL REGI METAL?
Checking the paper transfer path between the ROLL ASSY
13 FEED and ROLL ASSY REGI.
Are there any obstacles on the paper transfer path?
Checking the ACTUATOR REGI IN for shape and operation.
Remove the CHUTE ASSY LOW (PL3.2.27) once to check
14 the shape and operation.
Are the shape and operation of the ACTUATOR REGI IN
normal?
Checking the Regi. Sensor (SENSOR PHOTO) for
operation.
Does the number on the screen increase by one, when the
actuator (ACTUATOR REGI IN) is operated?
15
Remove the CHUTE ASSY LOW (PL3.2.27) once to check
the operation.
Checked by [Digital Input] - [Regi Sensor] in [IOT Diag] of
diagnosis.
Checking the Regi. Clutch (CLUTCH ASSY DRV) for
operation, and ROLL ASSY REGI and ROLL REGI METAL
for rotation.
Checked by [Digital Output] - [Regi Clutch] in [IOT Diag] of
diagnosis.
16
Does the Regi. Clutch (CLUTCH ASSY DRV) operate
properly, and the ROLL ASSY REGI and ROLL REGI
METAL rotate?
During this check, cheat the interlock switch (HARN ASSY
INTERLOCK AIO).
Check
2 - 128
Chapter 2 Troubleshooting
Remedy
Yes
Replace the KIT
HOLDER ASSY
Go to step 10.
SEPARATOR.
(Refer to REP2.2.)
Replace the KIT
ROLL ASSY
Go to step 11.
FEED. (Refer to
REP3.3.)
Replace the
CASSETTE ASSY
Go to step 21.
250 MG AIO.
(Refer to REP2.1.)
The paper lead
edge stay after the
ROLL ASSY REGI
Go to step 13.
and ROLL REGI
METAL, then go to
step 16.
Remove the
obstacles or stains
Go to step 14.
from the paper
transfer path.
Reseat the
ACTUATOR REGI
IN. (Refer to
Go to step 15. REP3.5.)
If broken or
deformed, replace
it.
Go to step 16. Go to step 25.
Go to step 17. Go to step 29.
No