Fuji Xerox DocuPrint CM305 df Service Manual page 242

Step
Checking the belt surface of the TRANSFER ASSY.
8 Are there any damages on the belt surface of the
TRANSFER ASSY?
Checking the TRANSFER ASSY for connection.
Open the COVER ASSY FRONT.
Are four HV terminals on the TRANSFER ASSY, and four
springs on the frame (PL4.1.11, 12, 13 and 14) dirty and/or
deformed?
9
Checking the PHD ASSY for connection.
Remove the PHD ASSY.
Are five HV terminals on the PHD ASSY, and five springs on
the frame (PL4.1.10 and PL4.1.15 to 18) dirty and/or
deformed?
10
Checking after replacing the PHD ASSY.
11 Replace the PHD ASSY. (Refer to REP4.6.)
Is the image printed correctly?
Check
3 - 20
Chapter 3 Image Quality Troubleshooting
Remedy
Yes
Replace the KIT
TRANSFER
ASSY. (Refer to
REP6.3.)
Clean or replace
the TRANSFER
ASSY or
SPRING(s).
Clean and/or
replace the PHD
ASSY or
SPRING(s).
End of work.
No
Go to step 9.
Go to step 10.
Go to step 11.
Warning: Start the
operation after the
FUSING UNIT has
cooled down.
Replace the
FUSING UNIT.
(Refer to REP6.1.)
After replacement,
be sure to clear
the life counter
value.