Fuji Xerox DocuPrint CM305 df Service Manual page 228

3.3 Image Quality FIP
FIP-1.P1 The output is too light
ESS and possible causative parts
- TRANSFER ASSY (PL6.1.7)
- PHD ASSY (PL4.1.21)
- DISPENSER ASSY (PL5.1.1)
- ROS ASSY (PL4.1.1)
- PWBA HVPS (PL4.1.19)
Before commencing troubleshooting, check the paper transfer path. Make sure there is no foreign
materials on the transfer path, such as staples, paper clips, scraps of paper and so on.
Step
Checking the error mode.
1
Does the error occur only during copying?
Checking the original.
2
Is the original color density low?
Checking the Default setting.
3 Is the [Lighter/Darker] of the [Copy Default] in the [Copy] of
the [Default Settings] the [Lighter 2 or 3]?
Checking the printing.
4 Checked by [Test Print] - [Gradation] in diagnosis.
Is the image printed correctly?
Changing the printer driver setting.
1.Reset Image Settings (Brightness/Contrast) to defaults.
- Click [Restore Defaults] in [Image Settings] on the
[Graphics] tab.
5
2.Disable Toner Saving Mode.
- Deselect the [Toner Saving Mode] check box on the
[Advanced] tab.
Is the image printed correctly?
Faint
Mnt01100KA
Check
Chapter 3 Image Quality Troubleshooting
Mnt01101KA
Go to step 2.
END, change the
original.
Set the [Normal]
or [Darker 1 to 3].
Printing data is
incorrect,then
check the printing
data which the
problem
generated.
End of work.
3 - 6
Remedy
Yes No
Go to step 4.
Go to step 3.
Go to step 5.
Go to step 5.
Go to step 6.