Fuji Xerox DocuPrint CM305 df Service Manual page 142

Step
Checking the connectors of the CLUTCH ASSY DRV (Regi
Clutch) for connection.
Check the connections between the PWBA MCU and
CLUTCH ASSY DRV.
Are P/J26 and P/J262 connected correctly?
30
Checking the HARNESS ASSY KSNR REGCL MG AIO for
continuity.
31 Disconnect J26 from the PWBA MCU.
Disconnect P262 from the CLUTCH ASSY DRV.
Is each cable of J26 <=> P262 continuous?
Checking the power to the CLUTCH ASSY DRV.
Disconnect J26 from the PWBA MCU.
32 Is the voltage across P26-4pin <=> ground on the PWBA
MCU, about +24 VDC when the Interlock Switch (HARN
ASSY INTERLOCK AIO) is pushed?
Checking the CLUTCH ASSY DRV for resistance.
Disconnect P/J262 of the CLUTCH ASSY DRV.
33
Is the resistance across J262-1 and J262-2 approximately
280-ohm?
Check
2 - 108
Chapter 2 Troubleshooting
Remedy
Yes
Reconnect the
connector(s) P/
Go to step 31.
J26 and/or P/J262
correctly.
Replace the
HARNESS ASSY
Go to step 32.
KSNR REGCL
MG AIO.
Replace the KIT
PWBA MCU.
Go to step 33.
(Refer to
REP8.10.)
Replace the KIT
Replace the
PWBA MCU.
CLUTCH ASSY
(Refer to
DRV.
REP8.10.)
No