Fuji Xerox DocuPrint CM305 df Service Manual page 232

FIP-1.P2 The entire output is blank
Before commencing troubleshooting, check the paper transfer path. Make sure there is no foreign
materials on the transfer path, such as staples, paper clips, scraps of paper and so on.
Step
Checking the error mode.
1
Does the error occur only during copying?
Checking the original.
2
Is the original placed correctly?
Checking the blank print.
3 Print the Windows test page.
Is the image printed correctly?
Checking the TONER CARTRIDGE (Y, M, C or K) for
installation.
4 Shake and reseat the suspected TONER CARTRIDGE (Y,
M, C, or K).
Is the image printed correctly?
Checking the TONER CARTRIDGE (Y,M,C or K).
5 Is the toner cartridges installed to the printer the XEROX
toner?
Set the Non-XEROX toner option to [Off].
(Refer to [Non-XEROX Toner] in "21 Understanding the Tool
6
Box Menus".)
Is the image printed correctly?
Checking the paper.
7 Is the installed paper with a new and dry one? or does the
paper satisfy the specification?
ESS and possible causative parts
- TRANSFER ASSY (PL6.1.7)
- PHD ASSY (PL4.1.21)
- DISPENSER ASSY (PL5.1.1)
- ROS ASSY (PL4.1.1)
- PWBA HVPS (PL4.1.19)
Check
3 - 10
Chapter 3 Image Quality Troubleshooting
Remedy
Yes
Go to step 2.
Go to step 4.
Printing data form
is not suitable for
the printer, then
check the printing
data which the
problem
generated.
End of work.
Go to step 7
End of work.
Go to step 8.
No
Go to step 3.
Set the original
correctly.
Go to step 4.
Go to step 5
Go to step 6
Go to step 7
Replace the paper
with a new and dry
one. or Change
the paper to the
one that satisfies
the specification.