Cimr-E2A0110 To 4A0415, 4A0058 To 4A1200 (Ip00 Enclosure) - YASKAWA E1000 Technical Manual

◆ CIMR-E2A0110 to 4A0415, 4A0058 to 4A1200 (IP00 Enclosure)
■
Removing the Terminal Cover
1.
Loosen the screws on the terminal cover, then pull down on the cover.
CAUTION! Crush Hazard. Do not completely remove the cover screws, just loosen them. If the cover screws are removed
completely, the terminal cover may fall off causing an injury. Take special care when removing/reattaching the terminal covers for
larger drives.
Note: The shape of the terminal covers and the numbers of screws differ depending on the drive models.
on page 32 for details.
Figure 3.15
2.
Pull forward on the terminal cover to free it from the drive.
Figure 3.16
■
Reattaching the Terminal Cover
Once wiring to the terminal board and other devices is complete, double check all connections and finally reattach the
terminal cover. Refer to Wiring the Main Circuit Terminal on page 78
page 83 for details on wiring.
Figure 3.17
Connect ground wiring first,
followed by the main circuit,
and then wire the control circuit.
YASKAWA ELECTRIC SIEP C710616 35D YASKAWA AC Drive E1000 Technical Manual
Figure 3.8 Removing the Terminal Cover on an IP00 Enclosure Drive
Figure 3.9 Removing the Terminal Cover on an IP00 Enclosure Drive
Figure 3.10 Reattaching the Terminal Cover on an IP00 Enclosure Drive
Refer to Component Names
YEC_common
YEC_common
and Wiring the Control Circuit Terminal on
YEC_common
3.5 Terminal Cover
3
67