YASKAWA E1000 Technical Manual page 308

7.4 Cooling Fan and Circulation Fan
■
Installing the Cooling Fan
Reverse the procedure described above to reinstall the cooling fan.
1.
Make sure the power lines for the fan are properly connected.
2.
Place the power supply connectors and cable back into the recess of the drive.
Figure 7.9
YEC_TMonly
Figure 7.9 Cooling Fan Power Supply Connectors: 2A0110 and 2A0138, 4A0058 and 4A0072
3.
Install the replacement fan into the drive.
Figure 7.10
Figure 7.10 Installing the Cooling Fan: 2A0110 and 2A0138, 4A0058 and 4A0072
4.
Angle the fan cover so the back end tilts up. Slide the cover into the small opening towards the front of the drive,
and then guide the entire fan cover into place.
Figure 7.11
Figure 7.11 Reattach the Fan Cover: 2A0110 and 2A0138, 4A0058 and 4A0072
308
A – Back
YEC_TM
only
B – Front
Insert the fan at an angle so that
it tilts towards the front of the
drive. Next press down on the
back of the fan that still protrudes
from the drive so that the fan
snaps into place.
Insertion area
Front of drive
Cross-Section
Fan cover Back of drive
Hook
YASKAWA ELECTRIC SIEP C710616 35D YASKAWA AC Drive E1000 Technical Manual
A
B
Back of drive
YEC_
TMonly
Hook
Front of drive