Ignition Curve Plug-In Connector; Changing The Ignition Curve; Checking The Basic Position Of The Shift Lever; Adjusting The Basic Position Of The Shift Lever - Husqvarna 125 XC-W 150 2017 Owner's Manual

Table of Contents

Advertisement

17
TUNING THE ENGINE
17.6

Ignition curve plug-in connector

17.7

Changing the ignition curve

Change the ignition curve from Performance to Soft.
Disconnect plug-in connector
Soft – better rideability
Change the ignition curve from Soft to Performance.
Join plug-in connector
Performance – better performance
17.8

Checking the basic position of the shift lever

Info
When driving, the shift lever must not touch the rider's boot when in the basic position.
When the shift lever keeps touching the boot, the transmission will be subject to an excessive load.
17.9

Adjusting the basic position of the shift lever

Plug-in connector
under the fuel tank.
Possible states
Soft – The plug-in connector of the ignition timing map adjustment is discon-
nected to achieve better rideability.
Performance – The plug-in connector of the ignition timing map adjustment is
joined to achieve higher performance.
E00374-10
of the ignition timing map adjustment. (Figure E00374-10
of the ignition timing map adjustment. (Figure E00374-10
Sit on the vehicle in the riding position and determine distance
upper edge of your boot and the shift lever.
Distance between shift lever and upper
edge of boot
»
If the distance does not meet specifications:
400692-10
Remove screw
401950-12
Info
If there is a big engine speed rise, reduce the idle speed to a normal level
and repeat the above steps.
If the procedure described here does not lead to satisfactory results, the
cause may be a wrongly dimensioned idling jet.
If you can turn the idle air adjusting screw to the end without any change of
engine speed, mount a smaller idling jet.
After changing the jet, start from the beginning with the adjusting steps.
Following extreme air temperature or altitude changes, adjust the idle speed
again.
of the ignition timing map adjustment is located on the frame
Adjust the basic position of the shift lever.
with washers and take off shift lever
p. 107)
p. 107)
between the
10... 20 mm (0.39... 0.79 in)
(
p. 107)
.
107

Advertisement

Table of Contents
loading

Table of Contents