17
ENGINE
17 .3.28
Removing the primary gear
17 .3.29
Removing the freewheel gear
17 .3.30
Removing the left engine case section
Remove internal rotor� and external rotor
-
Remove the pin.
48
-
Push oil pump shaft
side.
O
-
Insert special tool
in the crankshaft.
I
Protection cap (75029090000) (.- p. 224)
Install special tool @.
I
Extractor (75029021000) (.- p. 223)
-
Hold it using the special tool and pull off the primary gear by turning the screw in.
-
Remove the special tools.
O.
-
Remove woodruff key
-
Take off freewheel gear@.
O.
-
Remove screws
-
Mount special tool @ with the appropriate screws.
I
Case separating tool (90129048000) (.- p. 227)
•
Info
I
Use the drill hole marked with 781.
-
Tilt the left section of the engine case upward and remove the screw connections
of the engine fixing arm.
-
Take off the section of the engine case.
•
Info
I
Do not subject the section of the engine case to any stress.
-
Remove the special tool.
4'.
inward and take it out of the engine from the ignition
140