Removing A Memory Module - Huawei FusionServer Pro CH121 V5 V100R005 Maintenance And Service Manual

FusionServer Pro CH121 V5 Compute Node
Maintenance and Service Guide
Step 14 Check whether a PCIe card is installed.
l
l
Step 15 Install the PCIe card.
For details, see
Step 16 Install the air duct.
For details, see
Step 17 Install the cover.
For details, see
Step 18 Install the compute node.
For details, see
Step 19 Power on the compute node.
For details, see
----End

4.3.15 Removing a Memory Module

Removing a memory module
Step 1 Power off the compute node.
For details, see
Issue 06 (2019-08-10)
ii. Use a Phillips screwdriver to tighten the four screws (marked 2 in the label) in
the middle of the heat sink in a diagonal sequence. See (2) in
Figure 4-38 Installing the heat sink
If yes, go to Step 15.
If no, go to Step 16.
3.12 Installing a PCIe
3.8 Installing the Air
3.6 Installing the
3.4 Installing a CH121
3.2 Power-On
3.1 Power-Off
Copyright © Huawei Technologies Co., Ltd.
Card.
Duct.
Cover.
V5.
Procedure.
Procedure.
4 Parts Replacement
Figure 4-38.
85