Installing A Sas/Sata Drive - Huawei FusionServer Pro CH121 V5 V100R005 Maintenance And Service Manual

FusionServer Pro CH121 V5 Compute Node
Maintenance and Service Guide
Step 4 Remove the drive.
1.
2.
3.
Figure 3-22 Removing a drive
Step 5 Place the removed component in an ESD bag.
Step 6 Install a drive filler.
----End

3.14 Installing a SAS/SATA Drive

l The SATA or SAS drives support hot swap. After a faulty drive is disconnected from its
l To prevent damage caused by insufficient heat dissipation and high temperature, install
Issue 06 (2019-08-10)
Press the ejector release button on the drive panel to release the ejector lever. See (1) in
Figure 3-22.
Open the drive ejector lever completely. See (2) in
Holding the ejector lever of the drive, pull out the drive for about 3 cm (1.18 in.). Wait
for at least 30 seconds and remove the drive from the server. See (3) in
Do not insert or remove drives frequently. If a drive is frequently removed and installed
in an interval shorter than 30 seconds, there are risks that the drive cannot be identified.
NOTE
Perform this operation only when a drive is not installed immediately.
backplane, wait 30 seconds before removing it. The alarm will not be cleared immediately
after a new drive is installed. It will be cleared after the RAID array rebuild is complete.
Do not frequently hot-swap a drive to prevent new alarms.
components or filler panels.
Copyright © Huawei Technologies Co., Ltd.
3 Basic Operations
Figure 3-22.
Figure 3-22.
29