FusionServer Pro CH121 V5 Compute Node
Maintenance and Service Guide
Step 12 Place the removed component in an ESD bag.
Step 13 Install a processor socket cover.
1.
2.
Issue 06 (2019-08-10)
Figure 4-26 Removing a processor (2)
NOTE
Clean the removed processor and put it into an ESD bag.
NOTE
l Perform this operation only when a processor is not installed immediately.
l The processor socket cannot be exposed and must be covered by a processor or cover during
transportation and storage.
Aligning the processor socket cover with the guide pin on the processor socket, place the
cover on the processor socket. See (1) in
Press the positions shown by (2) in
Copyright © Huawei Technologies Co., Ltd.
Figure
4-27.
Figure 4-27
until you hear a click.
4 Parts Replacement
77