Omron G5 Series User Manual page 406

8 Operation
Control Mode
This indicates which control mode is in use: position control or speed control.
I/O Signal Status
Pin No.
... Input
... Output
This indicates the status of the control input and output signals connected to CN1 pin.
Switching between Input and Output Signals
Press
Switching between Input and Output.
Press to select the signal No. that you want to monitor.
8 - 10
Position control mode
Speed control mode
Reserved (Do not set any value.)
Reserved (Do not set any value.)
Input signal (Pin No.8) ON
Output signal (Pin No.10) OFF or Disabled.
... ON
... OFF or Disabled
It is possible to change the signal number
if the decimal point is located on the right
of the signal number.
to move the flashing decimal point.
It is possible to switch the I/O, if the decimal
point is located on the right of the I/O signal.
(Lowest No. of
Input signal)
(Highest No. of
Input signal)
OMNUC G5-series (Pulse-train Input Type) AC Servomotors and Servo Drives User's Manual
(Lowest No. of
output signal)
(Highest No. of
output signal)