Omron G5 Series User Manual page 355

Pn205 Notch 2 Width Setting
Setting 0 to 20
range
• Select the notch width of the second resonance suppression notch filter.
• Increasing the setting value widens the notch width. Normally, use the default set value.
Pn206
Notch 2 Depth Setting
Setting 0 to 99
range
• Set the notch depth of the second resonance suppression notch filter.
• Increasing the setting value shortens the notch depth and the phase lag.
Pn207
Notch 3 Frequency Setting
Setting 50 to 5,000
range
• Set the notch frequency of the third resonance suppression notch filter.
• When set to 5,000, the notch filter function is disabled.
Pn208 Notch 3 Width Setting
Setting 0 to 20
range
• Select the notch width of the third resonance suppression notch filter.
• Increasing the setting value widens the notch width. Normally, use the default set value.
Pn209
Notch 3 Depth Setting
Setting 0 to 99
range
• Set the notch depth of the third resonance suppression notch filter.
• Increasing the setting value shortens the notch depth and the phase lag.
Pn210
Notch 4 Frequency Setting
Setting 50 to 5,000
range
• Set the notch frequency of the fourth resonance suppression notch filter.
• When set to 5,000, the notch filter function is disabled.
Pn211
Notch 4 Width Setting
Setting 0 to 20
range
• Select the notch width of the fourth resonance suppression notch filter.
• Increasing the setting value widens the notch width. Normally, use the default set value.
Pn212 Notch 4 Depth Setting
Setting 0 to 99
range
• Set the notch depth of the fourth resonance suppression notch filter.
• Increasing the setting value shortens the notch depth and the phase lag.
OMNUC G5-series (Pulse-train Input Type) AC Servomotors and Servo Drives User's Manual
Unit –
Unit –
Unit Hz
Unit –
Unit –
Unit Hz
Unit –
Unit –
7 Parameter Details
Default 2 Cycle the
setting power supply
Default 0 Cycle the
setting power supply
Default 5,000 Cycle the
setting power supply
Default 2 Cycle the
setting power supply
Default 0 Cycle the
setting power supply
Default 5,000 Cycle the
setting power supply
Default 2 Cycle the
setting power supply
Default 0 Cycle the
setting power supply
All
–
All
–
All
–
All
–
All
7
–
All
–
All
–
All
–
7 - 21