Loading A New Switch Image; Loading A Saved Switch Configuration - Lenovo RackSwitch G8264CS Application Manual

Loading a New Switch Image

1. Set the FTP or TFTP server address where the switch image resides:
2. Set the area where the new image will be loaded:
3. Set the name of the image:
4. If you are using an FTP server, enter a username:
5. If you are using an FTP server, enter a password:
6. Initiate the transfer. To transfer a switch image, enter 2 (gtimg):

Loading a Saved Switch Configuration

1. Set the FTP, SFTP, or TFTP server address where the switch Configuration File
2. Set the name of the configuration file:
3. If you are using an FTP or SFTP server, enter a username:
4. If you are using an FTP or SFTP server, enter a password:
5. Initiate the transfer. To restore a running configuration, enter 3:
562
G8264CS Application Guide for ENOS 8.4
To load a new switch image with the name "MyNewImage-1.img" into image2,
follow these steps. This example shows an FTP or TFTP server at IPv4 address
192.168.10.10, though IPv6 is also supported.
Set agTransferServer.0 "192.168.10.10"
Set agTransferImage.0 "image2"
Set agTransferImageFileName.0 "MyNewImage-1.img"
Set agTransferUserName.0 "MyName"
Set agTransferPassword.0 "MyPassword"
Set agTransferAction.0 "2"
To load a saved switch configuration with the name "MyRunningConfig.cfg" into
the switch, follow these steps. This example shows an FTP, SFTP, or TFTP server at
IPv4 address 192.168.10.10, though IPv6 is also supported.
resides:
Set agTransferServer.0 "192.168.10.10"
Set agTransferCfgFileName.0 "MyRunningConfig.cfg"
Set agTransferUserName.0 "MyName"
Set agTransferPassword.0 "MyPassword"
Set agTransferAction.0 "3"