Example 2: Full Fabric Fc/Fcoe Switch - Lenovo RackSwitch G8264CS Application Manual

2. Enable tagging for internal ports participating in FCoE:
3. Specify all member ports for the VLAN:
4. Specify a VLAN for this Fibre Channel network:
5. Enable NPV mode on the VLAN:
6. Specify which external ports are connected to the upstream Fibre Channel full
fabric switch:
7. Remove unused ports—ports that are not part of the uplink to the Fibre Channel
fabric—from the NPV VLAN.

Example 2: Full Fabric FC/FCoE Switch

© Copyright Lenovo 2017
RS 8264CS(config)# interface port 1-4
RS 8264CS(config-if)# switchport mode trunk
RS 8264CS(config-if)# exit
RS 8264CS(config-vlan)# interface port 1-4
RS 8264CS(config-vlan)# switchport trunk allowed vlan add 1,1002
RS 8264CS(config-vlan)# interface fc 61-62
RS 8264CS(config-vlan)# switchport trunk allowed vlan add 1,1002
RS 8264CS(config)# vlan 1002
RS 8264CS(config-vlan)# npv enable
RS 8264CS(config-vlan)# exit
RS 8264CS(config-vlan)# npv traffic-map external-interface 61-62
RS 8264CS(config-vlan)# exit
Note: Although this example depicts two Fibre Channel ports connected to the
upstream device, this is done for the sake of network redundancy. Only one Fibre
Channel port is actually required.
Consider the following Fibre Channel network:
Figure 36. Using the G8264CS as a Full Fabric FC/FCoE Switch
Fibre Channel
Storage
Fibre Channel
Server
In this example network, the G8264CS acts as the full fabric switch for the Fibre
Channel network in two zones.
63
Zone1/2
Lenovo
Converged
Switch
64
Zone1
5
FCoE Zone1
6
FCoE Zone1
7
FCoE Zone2
8
FCoE Zone2
Chapter 18: Fibre Channel
343