Local Vm Groups - Lenovo RackSwitch G8264CS Application Manual

Local VM Groups

Configuring a Local VM Group
© Copyright Lenovo 2017
The configuration for local VM groups is maintained on the switch (locally) and is
not directly synchronized with hypervisors. Local VM groups may include only
local elements: local switch ports and LAGs, and only those VEs connected to one
of the switch ports or pre‐provisioned on the switch.
Local VM groups support limited VE migration: as VMs and other VEs move to
different hypervisors connected to different ports on the switch, the configuration
of their group identity and features moves with them. However, VE migration to
and from more distant hypervisors (those not connected to the G8264CS, may
require manual configuration when using local VM groups.
Use the following ISCLI configuration commands to assign group properties and
membership:
RS 8264CS(config)# virt vmgroup <VM group number> ?
cpu
flood
key <LACP LAG key>
optflood
port <port alias or number>
portchannel <LAG number>
profile <profile name>
stg <Spanning Tree group>
tag
validate <advanced|basic>
vlan <VLAN number>
vm <MAC>|<index>|<UUID>|<IPv4 address>|<name>(Add VM member to group)
vmap <VMAP number> [intports|extports](Specify VMAP number)
vport
(Enable sending unregistered IPMC to CPU)
(Enable flooding unregistered IPMC)
(Add LACP LAG to group)
(Enable optimized flooding)
(Add port member to group)
(Add static LAG to group)
(Not used for local groups)
(Add STG to group)
(Set VLAN tagging on ports)
(Validate mode for the group)
(Specify the group VLAN)
(Add a virtual port to the group)
Chapter 16: VMready
277