Lenovo RackSwitch G8264CS Application Manual page 249

5. Add ports, LAGs, and virtual pipes to their vNIC groups.
6. Save the configuration.
© Copyright Lenovo 2017
RS 8264CS(config)# vnic vnicgroup 1
RS 8264CS(vnic-group-config)# vlan 1000(Specify the VLAN)
RS 8264CS(vnic-group-config)# member 1.1(Add vNIC pipes to the group)
RS 8264CS(vnic-group-config)# member 2.1
RS 8264CS(vnic-group-config)# port 4
RS 8264CS(vnic-group-config)# port 11 (Add uplink port to the group
RS 8264CS(vnic-group-config)# failover (Enable vNIC failover for the group)
RS 8264CS(vnic-group-config)# enable
RS 8264CS(vnic-group-config)# exit
RS 8264CS(config)# vnic vnicgroup 2
RS 8264CS(vnic-group-config)# vlan 1774
RS 8264CS(vnic-group-config)# member 1.2
RS 8264CS(vnic-group-config)# member 2.2
RS 8264CS(vnic-group-config)# member 3.2
vNIC 3.2 is not enabled.
Confirm enabling vNIC3.2 [y/n]: y
RS 8264CS(vnic-group-config)# port 5
RS 8264CS(vnic-group-config)# trunk 1
RS 8264CS(vnic-group-config)# failover
RS 8264CS(vnic-group-config)# enable
RS 8264CS(vnic-group-config)# exit
Once VLAN 1000 and 1774 are configured for vNIC groups, they will not be
available for configuration in the regular VLAN menus (RS
8264CS(config)# vlan <VLAN number>).
Note: vNICs are not supported simultaneously on the same switch ports as
VMready.
(Select vNIC group)
(Add non‐vNIC port to the group)
(Enable the vNIC group)
Chapter 14: Virtual NICs
249